Discontinued
Note: Free Shipping only applies to lower 48 States. Please email springtailsolutions@gmail.com if
you are from Alaska or Hawaii for shipping rates.
International customers should purchase off of eBay for best
(and fastest) shipping options.
The production units for sale are BLACK
Grey is only used in the prototypes and for better detail for photographs
Includes....
One JL Rear Door Folding Rack (Black Powdercoat)
Hardware for assembly and mounting
Two Large STAT Pouches (SWAT Black)
What is it good for?
This is the perfect place to
keep your items that should be most accessible. Since the tail gate swings open
this is the perfect place to keep shackles and straps for recovery or any item
that you would like to keep in check during those rough off road excursions.
The MOLLE panel will drop into a “table” so you have somewhere to hold parts
for an ongoing trail repair or just serving up a picnic lunch.
Does it rattle?
This
is the most common question that we get from potential customers….The answer
is “Heck No!”
We
have spent considerable research in finding the best method to dampen any noise,
we settled on a combination of marine grade materials and tight tolerances achieved
by accurate laser cuts.
We offer the
tightest tolerances in the industry. Unlike the competition….if any components wear out,
they can be easily replaced.
Tell me about the features….
The JL Rear door
folding rack system offers a number of valuable features
Easy access to the back side of the rack for
threading MOLLE pouches
Adjustable
toggle latches rated at 220 pounds holding capacity each
Paracord suspension
with built in binders
High quality MPAC grid with precision
fitted components (patent# US D678,167S).
High quality BLACK powder coating for a long service
life
The MPAC rack converts into a fold down tray to hold
your tools or even just a picnic lunch
The rack is rated for about 24 pounds (as dictated by MOPARs table using the same mounting system, adjusted for weight difference).
NOTE: The rack was tested to 25 pounds in the
closed position. The weight limit on the open position may vary based on the
wear of the para-cord which may be subject to slip if too much weight is
applied. Always test the capability of the paracord not to slip under your
desired weight application before trusting it. If the paracord slips…then you
should tie off the upper para-cord hold so it does not slip.
As always, we
recommend that the tailgate rack be used for lighter cargo and that any heavier
items be properly secured on the cargo floor
Paracord suspension can provide needed
cordage in an emergency. Inexpensive to replace or to customize.
Completely
reversible with minimal modifications to your Jeep. Note: Requires Drilling access ports through plastic removable door panel
to access mounting points on the door. (Jeep designed it this way). Well-marked
and easy to do.
Is it really “Heavy Duty”?
When we say heavy duty, we
mean HEAVY DUTY! The JL MPAC Rear Door Folding Rack/table is composed of formed and
laser cut 16 gauge steel and the backing plate is manufactured from 11 gauge
steel. We have included the best quality hardware that we could find. Likely it
will outlast your vehicle.
Is the installation hard?
After the initial assembly of
the rack……installation takes less than 15 minutes and requires only basic hand
tools and a drill. The instructions are clear with illustrations. really, it could not be any
easier…we have thought of everything!
Dimensions
Folding tray/Grid: 27
¾ inches x 11 ½ inches
